ESC < > ENTER
0
F
5
ESC < > ENTER
I
F
5
p. 26 - Manual FA00945-EN - 01/2018 - © CAME S.p.A. - Translated original instructions
FINAL OPERATIONS
Once the operator is up and running and the users are registered, refit and fasten the covers without pinching any wires.
E1 Calibration error.
E2 Calibrating Encoder.
E3 Encoder is broken.
E4 Safety test error.
E7 Insufficient working time.
E8 Release hatch open.
E9 Closing obstruction.
E10 Opening obstruction.
E11 Maximum number of obstructions detected.
E15 Incompatible transmitter error.
E17 Wireless system error.
E 18 Missing wireless system configuration
ERROR MESSAGES
The error messages appear on the display.
Memory rollMemory roll
SAVING AND UPLOADING ALL DATA (USERS AND CONFIGURATION) WITH THE MEMORY ROLL
Procedure for memorizing all of the system's user and configuration data by using the Memory Roll, so they can be used with another control
board, even on another system.
Caution! Fitting and extracting the Memory Roll must be done with the mains power disconnected.
Fit the Memory Roll into the its corresponding connector on the control board. ❶
Select ON from the F50 and press ENTER to confirm the saving of data in the Memory Roll. ❷
Extract the Memory roll and fit it into the connector of another control board. ❸
Select ON from the F51 and press ENTER to confirm the uploading of data into the Memory Roll. ❹
After memorizing the data, it is best to remove the Memory roll.
To Next Page
Loading...
Need help?
General
