END OF INSTALLATION
STAGE 4
BEFORE STARTING STAGE 5 - Commissioning the
Control Panel
PLEASE CHECK THAT YOU HAVE CORRECTLY:
Ref Page
1. WIRED THE MOTORS AS SHOWN 4.1 13
2. WIRED IN THE SAFETY PHOTOCELLS 4.2 14
3. INSERTED THE RADIO FREQUENCY
CARD 4.3 14
4. WIRED IN THE TUNED ANTENNA 4.4 15
5. PROGRAMMED THE REMOTE CONTROLS 4.5 15
6. POWERED UP THE CONTROL PANEL 4.6 15
NOW STAGE 4 IS FULLY COMPLETED YOU ARE READY TO
BEGIN STAGE 5 OF YOUR FERNI AUTOMATION KIT
INSTALLATION
16
To Next Page
Loading...
