INSTALLATION INSTRUCTIONS
CONTENTS
1) Stage 1:- Civil & Mechanical Section Page
1.1 PRE-INSTALLTION CHECK 3
1.2 MOUNTING THE MOTOR BASE PLATE 4
2) Stage 2:- Wiring & Electrical
2.1 FITTING THE CONTROL PANEL IN THE CASING 7
2.2 BASIC CABLE LAYOUT 7
2.3 LOW VOLTAGE CABLE LAYOUT 7
3) Stage 3:- Installation Section
3.1 INSTALLING THE MOTORS 9
3.2 INSTALLING THE DRIVE ARMS 10
3.3 ADJUSTING THE OPEN & CLOSED CAMS 11
4) Stage 4:- Wiring & Electrical (2)
4.1 WIRING THE MOTORS 13
4.2 WIRING THE SAFETY PHOTOCELLS 14
4.3 INSERTING THE FREQUENCY CARD 14
4.4 WIRING IN THE TUNED ANTENNA 15
4.5 CODING THE REMOTE CONTROLS 15
4.6 POWERING UP THE CONTROL PANEL 15
5) Stage 5:- Commissioning the control Panel
5.1 INITIAL WIRING & CONTROL PANEL SETUP 17
5.2 OPENING & CLOSING THE GATES 18
5.3 CONTROL PANEL ADJUSTMENTS 19
5.4 AUTOMATIC CLOSE & SAFETY PHOTOCELLS 20
5.5 PROGRAMMING THE REMOTE CONTROLS TO THE
CONTROL PANEL 21
5.6 FINAL ASSEMBLEY 22
6) Troubleshooting Guide 24
7) Technical Information
7.1 TECHNICAL SPECIFICATIONS 26
7.2 MOTOR TORQUE SETTINGS 27
7.3 ZA4 CONTROL PANEL DESCRIPTION 28
7.4 ZA4 WIRING DIAGRAM 30
7.5 CONTROL PANEL ADJUSTMENTS 31
7.6 ELECTRICAL CONNECTIONS 32
8) Contact Information
To Next Page
Loading...
Need help?
General
