CAME GARD 8 SERIES - Barrier Assembly; Barrier Unit Preparation

N
M










p.
8
8 - Manual code:
FA01030-EN
FA01030-EN v.
1
1- 01/2018 - © Came S.p.A. - The manual's contents may be edited at any time without notice.
⚠
Caution! The barrier is set up for installing on the left.
If it is installed on the right, invert the direction of opening of the boom following the procedure below:
- loosen the grub screw on the motor arm, remove the spring bracket and the transmission connecting rod from the lever arm ;
- turn the lever arm 90° ;
- fasten the spring bracket and the transmission connecting rod from the opposite end of the lever arm and fasten the grub screw ;
- invert the motor phases M and N.
Preparing the barrier
Put the key in the lock and turn it anti-clockwise . Then lift up the dome cover and remove the inspection hatch .

Lever arm

Transmission connecting rod

Grub screw

Motor arm

Spring bracket