CAME GARD 8 SERIES - Travel Calibration Process; Automatic Calibration Guide

ESC < > ENTER
a3
ESC < > ENTER
i
ESC < > ENTER
cl i
ESC < > ENTER
op I
p.
23
23 - Manual code:
FA01030-EN
FA01030-EN v.
1
1- 01/2018 - © Came S.p.A. - The manual's contents may be edited at any time without notice.
1. Select A 3.
Press ENTER to confirm.
2. Select 1 and press ENTER to confirm the automatic travel
calibration.
Travel calibration


Before calibrating the travel, identify the type of boom, check that the boom is balanced and check that the manoeuvring area is
clear of any obstacles.
Important! During calibration, all safety devices will be disabled, excluding the TOTAL STOP device.
3. The operator closes until it reaches the limit-switch point...
4. ...then the operator opens until it reaches the limit-switch point.