2
INSTALLATION INSTRUCTIONS
CONTENTS
1) Stage 1:- Civil & Mechanical Section Page
1.1 BASIC HINGE GEOMETRY 3
1.2 BASIC CABLE LAYOUT 4
1.3 LOW VOLTAGE CABLE LAYOUT 5
1.4 ATTACHING THE REAR BRACKET 6
1.5 ATTACHING THE BRACKETS 8
2) Stage 2:- Wiring & Electrical
2.1 INSTALLING THE MOTORS 10
2.2 INSTALLING CENTRE STOPS 11
2.3 MANUAL RELEASE OF GATES 12
2.4 FITTING THE CONTROL PANEL IN THE CASING 13
2.5 WIRING THE MOTORS 14
2.6 WIRING THE SAFETY PHOTOCELLS 15
2.7 INSERTING THE FREQUENCY CARD 15
2.8 WIRING IN THE TUNED ANTENNA 16
2.9 CODING THE REMOTE CONTROLS 16
2.10 POWERING UP THE CONTROL PANEL 17
3) Stage 3:- Commissioning the Control Panel
3.1 INITIAL WIRING & CONTROL PANEL SETUP 18
3.2 OPENING & CLOSING THE GATES 19
3.3 CONTROL PANEL ADJUSTMENTS 20
3.4 AUTOMATIC CLOSE & SAFETY PHOTOCELLS 21
3.5 PROGRAMMING THE REMOTE CONTROLS TO THE CONTROL PANEL 22
4) Troubleshooting Guide 24
5) Technical Information
5.1 MOTOR TORQUE SETTINGS 26
5.2 ZA4 CONTROL PANEL DESCRIPTION 27
5.3 ZA4 WIRING DIAGRAM 28
5.4 CONTROL PANEL ADJUSTMENTS 29
5.5 ELECTRICAL CONNECTIONS 30
7) Contact Information
“Time marches on but Came automation equipment stands the test of time...”
To Next Page
Loading...
