Page 10 - Manual FA01768-EN - 07/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
INSTALLATION
The following illustrations are examples only. The space available for fitting the operator and accessories varies depending on the area where it is
installed. It is up to the installer to find the most suitable solution.
Preparing the guide
M6 x 20
M6
Positioning the guide
Sectional doors
Position the guide above the space for the bracket on the spring pole, observing the measurements shown in the diagram.
If the distance between the spring pole and the upper part of the door is between 300 mm and 600 mm, use the V122 transmission arm (accessory not
supplied).
20÷30
300÷ 600
Overhead garage doors
A
For overhead garage doors with springs (fully retracting), position the guide 20 mm above the highest point during opening.
B
For counterbalanced garage doors (partially retracting), use the V201 transmission arm (accessory not supplied).
20
A
V201
B
To Next Page
Loading...
