CAME ZR24 - General Installation Instructions; Preliminary Checks; Tools and Materials

Page
5
5 - Manual code:
319T07EN
319T07EN
ver.
3
3 05/2014 © CAME cancelli automatici S.p.A.
The data and information provided in this manual are subject to change at any time without prior notice.
GENERAL INSTALLATION INSTRUCTIONS
Preliminary checks
Before installing the control panel:
- Make sure that the area chosen for fastening is protected
from potential impacts and that the surface is solid.
- Provide a suitable single-pole disconnection device, with a
maximum of 3 mm between the contacts, to disconnect the
power supply;
-
Make sure that any connections within the container
(made to ensure the continuity of the protection circuit)
are fitted with additional insulation compared to the other
internal conductor parts;
- Prepare suitable piping and ducts for routing the electrical
cables, ensuring protection against mechanical damage.
Tools and materials
Make sure you have all the tools and materials you will need
for the installation at hand to work in total safety and compli-
ance with current standards and regulations. The figure shows
some examples of installer’s tools.