Cameron BARTON 289A - Default Chapter; Technical Support

A-2
Safety
Before installing this product, become familiar with the installation instruc-
tions presented in Section 3 and all safety notes throughout.
WARNING:Thissymbolidentiesinformationaboutpracticesorcircum-
stances that can lead to personal injury or death, property damage, or
economic loss.
CAUTION: Indicates actions or procedures which if not performed correctly
may lead to personal injury or incorrect function of the instrument
or connected equipment.
IMPORTANT: Indicates actions or procedures which may affect instrument operation or
may lead to an instrument response that is not planned.
3-3/4-inch Diameter Bellows Without Kickoff Spring (>47" w.c.) .............. A-22
3-3/4-inch Diameter Bellows with Kickoff Spring ....................................A-23
Setting Bellows Travel..............................................................................A-25
Bellows Unit Assembly (BUA) Replacement
............................................ A-25
Attaching Drive Arm to Torque Tube ........................................................A-26
Drive Arm Tightness Test
.........................................................................A-27
Adjusting Pulsation Dampener.................................................................A-27
Troubleshooting .......................................................................................A-27
Section 5—Parts Drawing/List .................................................................A-30
Section 6—Dimensional Drawings
..........................................................A-35
Technical Support
Cameron
Measurement Systems Division
14450 John F. Kennedy Blvd.
Houston, TX 77032
Phone: 1-800-654-3760; 281-582-9500
Fax: 281-582-9599
Barton is a registered trademark of Cameron.
© 2012 Cameron International Corporation (“Cameron”). All information contained in this
publication is condential and proprietary property of Cameron. Any reproduction or use
of these instructions, drawings, or photographs without the express written permission of
an ofcer of Cameron is forbidden.
All Rights Reserved.
Printed in the United States of America.