26
Load a fully-charged Battery Pack LP-E6 into the camera.
1
Open the battery compartment
cover.
Slide the lever as shown by the arrow
and open the cover.
2
Insert the battery.
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
3
Close the cover.
Press the cover until it snaps shut.
Open the cover and remove the
battery.
Press the battery release lever as
shown by the arrow and remove the
battery.
To prevent short circuiting of the
battery contacts, be sure to attach the
protective cover to the battery.
Installing and Removing the Battery
Installing the Battery
Removing the Battery
Only the Battery Pack LP-E6 can be used.
To Next Page
