Troubleshooting Guide
If a problem occurs, first refer to this Troubleshooting Guide. If this
Troubleshooting Guide does not resolve the problem, contact your
dealer or nearest Canon Service Center.
Power-Related Problems
The battery pack does not recharge.
~
If the battery's remaining capacity (p.230) is
94%
or higher, the battery
will not be recharged.
4&
Do
not
recharge
any
battery
pack
other
than
genuine
Canon
Battery
Pack
LP-E6.
The charger's lamp blinks at high speed.
~
If there
is
a problem with the battery charger or battery pack or if
communication with the battery pack (non-Canon battery packs)
is
not
possible, the protective circuit will terminate the charging and the orange
lamp will blink quickly at a regular interval. If there
is
a problem with the
battery charger or battery pack, unplug the charger's power plug from the
power outlet. Detach and reattach the battery pack
to
the charger. Wait 2
to 3 minutes, then reconnect the power plug to the power outlet. If the
problem persists, contact your dealer or nearest Canon Service Center.
The charger's lamp does not blink.
$ If the internal temperature
of
the battery pack attached to the charger
is
high, the charger will not charge the battery for safety reasons (lamp
off). During the charging, if the battery's temperature becomes high for
any reason, the charging will stop automatically (lamp blinks). When the
battery temperature goes down, the charging will resume automatically.
The
camera
does
not
operate
even
when
the
power
switch
is
set
to
<
ON
>.
..
The battery is not properly installed
in
the camera (p.26).
(It
Recharge the battery (p.24).
• Make sure the battery compartment cover is closed (p.26).
• Make sure the card slot cover is closed (p.29).
243
I
To Next Page
