Canon image RUNNER 3245 - Page 56

Communication Environment Setup
4-14
4
Settings Common to the Network Protocols
An SNMP v. 3 user with the following settings is registered by default. Delete or change these settings as necessary.
User: initial
MIB Access Permission: Read/Write
Security Settings: Auth Yes/Encrypt Yes
Authent. Algorithm: MD5
Authent. Password: initial
Encryption Password: initial
If you want to add an SNMP v. 3 user:
Press [User Settings] → [Register] → specify the user name, MIB permissions, and security settings.
If you select [Auth Yes/Encrypt Yes] from the Security Settings drop-down list, select the
authentication algorithm → enter the passwords for authentication and encryption. If you select
[Auth. Yes/Encrypt. No] from the Security Settings drop-down list, select the authentication algorithm
→ enter the password for authentication.
If you want to confirm or change the SNMP v. 3 user settings:
Press [User Settings] to select the user whose settings you want to confirm or change → press
[Details/Edit].
Confirm the displayed information → change the settings if necessary.
If you want to erase an SNMP v. 3 user:
Press [User Settings] to select the user whose settings you want to erase → press [Erase].
If you want to change the status of an SNMP v. 3 user:
Press [User Settings] → select the user whose status you want to change → press [User On/Off].
-
-
-
-
-
-
●
☐
●
☐
●
☐
●
☐