7-25
Routine Maintenance
7
Adjusting the Printing Position
In this case, adjust the printing position by -5.0 mm upward.
IMPORTANT
OFFSET Y (DUP.) and OFFSET X (DUP.) allow you to specify the printing position of the
first page of 2-sided printing. The second page of 2-sided printing follows the settings for
each paper source.
NOTE
The printing position can be adjusted within a range from + 5.0 to - 5.0 mm.
1
Press the (Online) key.
The (Online) indicator goes off, allowing you to specify the settings on the
control panel.
2
Press the (Settings) key.
3
Select USER MAIN. using [ ] and [ ], then press [OK].
The item for USER MAIN. is displayed.
Top
Feeding
direction
SETUP
CONTROL MENU
→
USER MAIN.
→
ADJ.START POS.
→
To Next Page
Loading...
