Prevent any outgoing connection to the Internet
Introduction
Some features of the following systems allow or request a connection over the Internet to work
properly:
• Océ PlotWave 300 R1.5 and higher
• Océ PlotWave 350 R1.5 and higher
• Océ ColorWave 300 R1.5 and higher
When the Security Policy in a company prevents any outgoing network traffic over the Internet,
perform all the following actions in Express WebTools:
St
ep
In the Express WebT‐
ools section
Action Detail
1 Support - Remote Serv-
ice - Remote assistance
Stop the Remote assistance if is ac-
tivated
Click 'Stop remote assis-
tance' until it changes into
'Allow remote assistance' .
The two blinking arrows
on the right side disap-
pear.
2 Preferences - System
Defaults - Service rela-
ted information
Disable Online Services Set 'Océ Online Services
connection enabled' to
'Disabled'
3 Configuration - Scan
destination [X]
Delete any scan destination going to
the Internet:
FTP sites reachable through the In-
ternet
Uncheck 'Scan destination
[X]: enabled'
4 Support - About - Shut-
down - Restart
Restart the system
Prevent any outgoing connection to the Internet
Chapter 2 - Security on Océ PlotWave 300/350, PlotWave 750, PlotWave 900 and ColorWave 300
31
To Next Page
Loading...
