Canon Powershot SD700 IS

Printer error
Printer in use
Printer cover open
No print head
Disconnect the cable from the printer and turn off
the printer power. Then reconnect the cable and
turn on the printer. If the error persists, please
request a repair from your nearest Canon Customer
Support Center (listed in the Contact List provided
with the printer).
The printer is
in use now. The printer automatically
starts printing the images from the camera after
completing the current printing.
Adjust the paper thickness lever to the proper
position.
Close the printer cover securely.
Ifthe printer's error lamp is blinking and an error
message is displayed, please refer to the printer's
user guide to ascertain the problem and its remedy.
File Error
Hardware Error
If the printer's error lamp is blinking and an error
message is displayed, please refer to the printer's
user guide to ascertain the problem and its remedy.
III
-------
You tried to print an image that is not compatible
with PictBridge. Some images that have been
recorded with another camera or modified using a
computer cannot be printed.
Incompatible paper
size
Print error
Check print
settings
Paper
of a different size than the specified paper
size
is set to the printer. Select [Continue] on the
error screen to display the paper size setting
screen. Correct the paper size using the screen
(only the selectable paper sizes appear
on the
screen).
Check that the correct paper size is selected. If this
error message appears even when the correct
paper size is set, turn off the printer, then turn it on
again. If the error persists, please request a repair
from your nearest Canon Customer Support Center
(listed
in the Contact List provided with the printer).
Unprintable settings are included. Select [Continue]
on the error screen to display the print order screen.
Check the print settings (only the printable settings
appear on the screen), change the settings
if
necessary, then print again.
51