Canton Smart Series - Assigning Preset 1-3

3
35
English
7
Now plug the mains cable of the new loudspeaker into the socket
and/or switch it on at the mains switch.
8
About 10 – 20 seconds after turning on the speaker, the LED displays
should show [CON] (connected).
9
To pair additional Smart speakers wirelessly, repeat the steps 5–8 and
pair the desired speaker to the corresponding channel.
ASSIGNING PRESET 1–3
The Smart speakers are able to assign presets to the three memory buttons
on the Smart remote control. All currently selected settings like input, volume,
sound settings, play-mode as well as the settings within the speaker setup
menu (gain, EQ , etc.) can be stored this way.
Saving / recalling settings
1
Please apply the desired settings regarding volume, sound, input etc. and
in case the settings in the speaker menu [SPS].
2
To save your selections press and hold the memory button 1, 2 or 3 until
the corresponding number [P1], [P2] or [P3] is shown in the display of the
Smart speaker and no longer flashes.
3
To recall the settings from these presets, press the corresponding button
1, 2 or 3 briefly. The Display shows the selected preset [P1], [P2] resp. [P3]
for confirmation.
Note:
• To delete the settings from a preset button, please press and
hold the relating button for 10 seconds until the corresponding preset
[P1], [P2] or [P3] is shown in the display rapidly flashing.