3
31
English
Analog Line (L+R) input
1
Connect the Analog Line input (2) of the Smart speaker (master) and the
Analog Line output of your audio device with the analog stereo audio
cable.
2
Now select the input [AUX] by using the up and down arrows
( , )
on the
Smart remote control and start playback on the audio device.
Analog Balanced input (Mono-input)
1
Connect the ANALOG BALANCED input (1) of both Smart Speaker to the
balanced (XLR) outputs of your audio device. These inputs are single
channel inputs (mono), therefore both speakers must be connected to
your audio device.
2
Now select the [XLR] input by using up and down arrows
( , )
on the
Smart remote control and start playback on the audio device.
Note:
• The required balanced (XLR) signal cables are not part of the delivery
content.
MENU STRUCTURE AND NAVIGATION
To simplify the menu navigation of your Smart speakers, here you will find the
most important commands for controlling the speaker menu:
• To call up the menu, press the „M“ button (menu).
• To go to the next menu level, press the „OK“ button.
• To navigate within the menu level, press the „
/
“ buttons.
• To change the value of a parameter, press the „+/−“ buttons.
• To return to the previous menu level, press the „M“ button.
• To leave the menu, keep it pressed for about 3 seconds.
To Next Page
