CanyCom S100 - Storage (Long-term Storage)

- 45 -
Maintenance
7
7.8.3 V-belt for Traveling
Inspection
V-belt for traveling
Lock nut
1. Push the clutch lever to the [ (ON)] position.
Tension arm
Spring
Turnbuckle
2. Remove the safety cover. (See page 42)
3. Visually check the traveling V-belt for damage.
If it is damaged, replace.
Spring
114~118mm
Slippage of V-belt
After loosening the lock nut, and adjust the spring
hook inner dimension to 114 to 118 mm by turning
the turnbuckle.
Replacement
Contact your Canycom distributor.
7.8.4 hydraulic pressure V-belt
Adjustment nut
Lock nut
Spring
Tension arm
Inspection
1. Open the engine cover, and lock it with the stay-bar.
(See page 15)
2. Visually check the hydraulic pressure V-belt for
damage.
If it is damaged, replace.
Slippage of V-belt
After loosening the lock nut, and adjust the spring
hook inner dimension to 65 to 68 mm by turning the
adjustment nut.
Replacement
Contact your Canycom distributor.
Spring