Safety
-4-
1
Operation
• Fuel is highly ammable. See Checking and Filling Fuel, page 15, for important
safety information on handling fuel.
• Do not operate the engine in a conned space where dangerous carbon monoxide
fumes can accumulate.
• Do not touch the engine, mufer or exhaust pipe while the engine is running or soon
after it has stopped. These areas will be very hot and can cause burns.
This machine is intended for carrying sand and dirt. Carrying other materials may damage
the machine. Avoid carrying liquid concrete. That will damage the machine.
The stability of the machine is affected by the speed, rate of steering, terrain and the load.
Always pay close attention to these factors or a loss of control or tip over could occur,
resulting in property damage, serious injury or death.
General Driving
• Always wear protective footwear, long trousers, hardhat, safety glasses and ear
protection when operating or servicing the machine. Proper clothing will minimize
the chance of injury. Do not operate the equipment if you have long hair, loose
clothing, or jewelry; all of which may get tangled in moving parts. Do not operate
the machine barefoot or with open sandals.
• Prepare beforehand the working rules and procedures such as signaling and trac
control for the work place. Following such rules will reduce the risk of accidents.
• Never handle fuel or grease, service the engine, or recharge the battery in the
presence of re or spark.
• Perform the daily pre-startup inspection (see Preparation, pages 15-18) before
starting the machine. Repair or replace damaged parts before starting the machine.
Preparation
To Next Page
Loading...
