CanyCom S160 - Page 43

Maintenance
-34-
5
Item Description
Schedule
Note
PSI
Mon
Year
Engine
Electrical System
Charge
System
Charge system is working correctly.
√
Contact your CANYCOM
representative for
inspection.
Battery
Battery electrolyte level shall be correct.
√ √
Inspecting/Filling:
Page 55
Terminals shall be free of marked corrosion
and are tightly secured.
√ √
Wiring
Connections shall be securely connected.
√ √
Wiring shall be free of damages.
√ √
Drive Train
Clutch
Clutch shall not make noise and shall
disengage completely when operated at idle.
√ √
Clutch shall not slip and shall engage
smoothly.
√ √
Drive Belts
Belt tension shall be properly adjusted.
√ √
Inspecting/Adjusting:
Page 51
Belt shall be free of damage, excessive
wear, or dirt; shall be free of oil or grease.
√ √
Transmission
Irregular noise or overheating shall not be
observed.
√ √ √
Oil shall be clean and filled to the proper
level.
√ √
Replacing: Page 49
There shall not be oil leaks in or around
transmission.
√ √
HST Pump
Drive the machine forward and backward,
turn left and right in both directions; machine
shall move normally and free of irregular
noise or overheating.
√ √ √
Hydraulic fluid shall be filled to a proper
level.
√ √
Inspecting/Changing:
Page 47
Hydraulic uid shall be clean and free of dirt
or contamination.
√ √
Inspecting/Changing:
Page 47
There shall be no fluid leaks in or around
uid tank.
√ √
Linkage
Rods, links, and wires in linkage shall be free
of deformation or damage.
√ √
Connections shall be free of looseness,
excessive play, or missing cotter pins.
√ √