OPERATOR MANUAL |CAPTAIN 273 4WD 88
Remove the level plug (2) (Fig. 5-15) from the central axle housing. The oil level must reach the hole.
Top up if necessary with oil of the specified type through the plug (2) (Fig. 5-15).
NOTE: See the fuel and lubricant chart for the correct type of oil.
5.34 OPERATION 13
Miscellaneous inspections
• Hand brake lever: make sure that the ratchet mechanism locks in a secure and stable way.
• Make sure that the wheel nuts are correctly torque. Make sure that the safety frame screws are well
tightened.
• Make sure that all other nuts and bolts are well tightened.
• Check the tyres pressure.
Safety frame
Have your Dealer's specialized personnel check to make sure that the safety frame fixing screws are
correctly tightened.
WARNING: The safety frame complies with certain safety standards. It must never be drilled or
modified in order to install accessories or implements. It is FORBIDDEN to weld on accessories
or repair the safety frame by welding.
Dashboard control coatings
CAUTION: Use water and a neutral detergent to clean the coating of dashboard and controls. Any
commercial product to clean car interiors may be used. DO NOT use any kind of solvents or alcohols.
To Next Page
Loading...
