10
POSITIONING
-
-
-
= 30÷70%
non-condensing
> 5°C30°C >
>700mm <960mm
150mm
04
The consents and the procedures
described below mu be per-
formed by a skilled technician.
POWER MAINS CONNECTION
Before connecting the machine to
the power supply, make sure that
the power switch is in the “0” posi-
tion and that the data on the plate
correspond to those of the electri-
cal diribution network.
The connection to power mains
mu be done by a skilled techni-
cian in compliance with applicable
regulations.
In the case of a machine with direct
connection to the electrical panel,
where there is no plug, make sure
that the connection point incorpo-
rates an omnipolar disconnection
device suitably sized according
to the electrical power of the ma-
chine (see plate), with an opening
diance of the contacts allowing
complete disconnection in over
voltage category III.
DANGER
To Next Page
Loading...
