37
Required tools for cleaning:
● Brush (CARIMALI 95.01806);
● Hot water;
● Cleaning agent.
Immerse all components in a solution
of hot water and cleaning agent CA-
RIMALI.
34
Brush the Milker dispensing nozzle
with the brush to remove the residues.
Make sure that the components are
completely dry before re-inalling
them in the machine to avoid the
proliferation of bacteria.
Reassemble the Milker in reverse or-
der.
5.5 STEAM WAND WASHING
Wash every day at the end of the
work shift.
1. Take a 500ml container with cold
water and mix with CARIMALI liq-
uid detergent (06.00136). For dos-
es, see the product label.
2. Insert the eam wand into the
container and lower and raise the
eam lever (1 second low, 10 sec-
onds high), a total of 10 repetitions.
22
1
10’’
1’’
3535
3. Remove the eam wand and dis-
card the liquid.
4. Fill the container again with cold
water only and repeat ep 2.
5. Remove the eam wand and dis-
card the liquid.
6. Complete the procedure by per-
forming the operations in point 2
three times without load.
Make sure you have thoroughly
cleaned the part in contact with
liquids (from the sealing rubber to
the nozzle).
To Next Page
Loading...
