40
1. Remove the sprayhead by un-
screwing the screw (A) located in
the centre. The block will auto-
matically fall down.
A
4444
2. Also remove the gasket (B) and de-
tach the o-ring (C) from the block.
C
B
4545
3. Prepare a tall container with about
500ml of very hot water and in-
sert a tablet of Carimali detergent
(06.00133).
4. Soak all metal parts for about 10
minutes.
5. When nished, remove the com-
ponents from the container and
rinse them under running hot wa-
ter, rubbing them with the brush
supplied.
Reassemble the sprayhead, the lter
and the lter holder, proceeding in re-
verse order.
NOTE
To replace the gaskets or other con-
sumable components, refer to the
Manufacturer’s maintenance plan
or to the ate of wear of the parts
themselves.
To Next Page
Loading...
