13
1 Synoptic screen access button
2 Main Menu access button
3 User Login screen access button
4 Unit Start/Stop access button
5 Alarm menu access button
6 Setpoint
7 Unit capacity percentage (motor load current percentage)
8 Guide Vane Position percentage
9 Oil temperature
10 Oil pressure delta
11 Condenser pump status (hydraulic System option is Enabled)
12 Evaporator pump status (hydraulic System option is Enabled)
13 Condenser water inlet and outlet temperature
14 Evaporator water inlet and outlet temperature
15 Condenser saturated temperature and pressure
16 Evaporator saturated temperature and pressure
Message: all screens described below can display an
information message in the band at the bottom.
COMMUNICATION
FAILURE!
Equipment controller did not respond while reading the
table content.
ACCESS DENIED! Equipment controller does not allow accessing one of the
table data blocks.
LIMIT EXCEEDED! The value entered exceeds the table limits.
Save changes? Modications have been made. The web interface waits to
conrm exit by pressing Save or Cancel.
HIGHER FORCE IN
EFFECT!
Force or Auto command was rejected by the equipment
controller because the interface force level is lower than the
equipment controller’s.
The On/Off screen allows users to select the unit operating
mode.
4.7.1 - Unit Start-up
With the unit in the Local Off mode, press the button
to display the list of operating modes. Select the expected
mode to startup the chiller
Shows the
last mode
selected
Operating
mode list
4.7.2 - Unit Stop
To Stop the unit - press the following button:
Conrm the unit shut-down or return to the previous screen.
To Next Page
Loading...
