Carrier PIC 5+ - 7 Colour Touch Screen Interface Parameter Setting; Main Configuration Menu; Find and Modify the Unit IP Address; Configuration of the Web Connection

47



The “Setup” display is only possible on the unit touch screen.
To access the main conguration menu, press anywhere and
at any time on the screen (excluding buttons or text elds)
for 4 seconds.
By default, access to the menu is not password-protected.
The main conguration screen gives access to various unit
parameters:
B
D
E
F
G
H
C
I
1 System properties for the Ethernet interface
2 Connection conguration, web welcome page
3 System: Software version, Buzzer
4 Display: Contrast, backlighted
5 Keyboard: Not applicable
6 Password for "Setup" access
7 Languages: for "Setup" only
8 Return to application

In the main conguration menu (see chapter 7.1) press on
the network eld “Network” to display the screen below.
B
D
E
F
G
C
1 Enable DHCP
2 IP address
3 Subnet mask
4 Default gateway
5 Primary DNS Server
6 Secondary DNS Server
If “Enable DHCP” is checked, PIC 5+ will automatically
get IP settings from DHCP server, no need to set other items.
NOTE: You must request an IP address, the subnet mask
and the default gateway from the network administrator
before connecting the unit to the local Ethernet network.
To change IP address manually, press on the second line with
the IP address.
Enter the new address and validate it by pressing “OK”.
Proceed in the same way with other network parameters.
Return to the application and save.

This conguration is carried out at the factory and is not
normally modied.
In the main conguration menu (see section 7.1), press on
the “Web Connection” eld.
The screen presented below is displayed:
B
D
E
F
C
Press “Edit Connection”