Carrier PIC 5+ - Install Vent Piping to Relief Devices; Purge Discharge Connection; Step 5: Electrical Connection

48
B
D
E
F
G
C
Default parameters for the application are given. Press a
specic parameter to modify it in case it’s not compliant with
the screen given above.
1 Connection Name:startup
2 Start page name: hmi.html
3 Remote host IP: Not applicable for the application. Do not modify.
4 Remote port: Not applicable for the application. Do not modify.
5 Remote password: Not applicable for the application. Do not modify.
6 Remote info: Not applicable for the application. Do not modify.

In the main conguration menu (see section 7.1), press the
“System” eld.
The screen below is displayed:
B
D
E
F
G
C
1 Software version
2 System Settings
3 Reset to zero and ash formatting, clock parameters (do not modify)
4 Unit start-up history
5 Firmware update (not applicable)
6 Unit reboot
Press on the rst eld of the system screen to display the
software version as well as the unit serial number.
B
D
E
F
C
1 Indicate the rmware version which loaded in this panel
2 Indicate the bootloader version which loaded in this panel
3 CPLD version
4 Show the detailed production data of this panel
5 Information regarding the extended hardwares
B
D
C
1 Interface order: local before remote (do not modify)
2 Start-up delay time (do not modify)
3 Information on the system start-up screen
Return to the previous screen: “System “.
Press the fourth eld “Intro screen” on the screen to display
the conguration of the start-up information.
B
C
1 Welcome message at the start-up of the application: Welcome
2 Display of the Carrier logo at the start-up of the application
The default values are shown above.