62-11863 3-4
3.5 STARTING UNIT - ELECTRIC / STANDBY OPERATION
Under no circumstances should ether or any other starting aids be used to start engine.
Make sure the power plug is clean and dry before connecting to any electrical outlet / receptacle.
Do not attempt to connect or remove power plug or perform service and/or maintenance before
ensuring the unit RUN/STOP switch is in the STOP position, the I/O switch is in the OFF (O)
position and the external power circuit breaker is OFF.
1. Place the unit RUN/STOP switch, which is located on the side of the electrical box, in the STOP position.
2. Place the I/O switch in the OFF (O) position.
3. Connect the standby cable to the unit and then turn the external power circuit on.
4. Place the unit RUN/STOP switch in the RUN position.
5. Place the I/O switch in the RUN (I) position.
6. Press the ROAD/STANDBY key until the STANDBY icon is displayed.
7. Press and hold the UNIT DATA/COMP. key to go to compartment selection mode.
8. Select the desired compartment using the UP and DOWN arrow key.
The microprocessor performs a self-test (all display messages appear in display window), after which
time the setpoint and refrigeration compartment temperature is displayed.
To Next Page
Loading...
