62-11863 3-18
3.13 STOPPING UNIT
Always place the RUN/STOP switch in the STOP position and turn off the power supply before
disconnecting the power plug from the unit.
1. Press and hold the UNIT DATA / COMP. key to go to Compartment Selection mode.
2. Select the desired compartment using the UP and DOWN arrow key.
3. Place C1 and C2 in the OFF position using the ENTER key.
4. Place the I/O switch in the OFF (O) position.
The diesel engine/electric motor will stop and the microprocessor display will turn off.
If both compartments are stopped and the unit RUN/STOP switch is still in the RUN position, the unit
will stop but the microprocessor will stay energized.
3.14 REMOTE PANEL
The optional remote panel is a user-friendly indicator and control that enables the operator to view compartment
temperatures. The panel can be mounted to suit the individual operator’s preference.
From this control panel (option) the operator can turn the unit on and off, check temperature in either compartment,
change set points, or initiate a manual defrost (refer to Section 3.9).
To Next Page
Loading...
