62-11039 3-22
3.15 VIEW HOURMETERS
COOL DEFROST ALARM START-STOP
SETPOINT BOX TEMPERATURE
ALARM LIST
SELECT
MANUAL
DEFROST
HEAT CONTINUOUS
+36 F
-20
START--STOP/
CONTINUOUS
2
TOTAL ENGINE HOURS: 0 HRS
1. Press the SELECT key until the
MessageCenter displays
“PRESS ↑↓ TO VIEW HOURMETERS”.
2. Press the UP or DOWN ARROW key to move
through the Hourmeter List.
5. Selected Hourmeter will remain in the
MessageCenter for 10 seconds, then the default message (STATUS OK)
or other customer specified message) will appear.
6. To lock an hourmeter in the MessageCenter, press the = key.
The Data item will flash continuously to indicate it is locked.
7. Pressing any key on the keypad will unlock the item. Pressing the
UP or DOWN ARROW key will move to the next hourmeter.
3. Displayed hourmeters will depend on unit configurations (See Section 5.2.1). Typical
displayed meters are: “TOTAL ENGINE HOURS”,
“STANDBY RUN HOURS” and “TOTAL SWITCH ON HOURS”.
4. Pressing the = key will access all other meters and display
“OTHER METERS AND COUNTERS”.
Hourmeters available when “OTHER METERS AND
COUNTERS” is chosen are:
SMeters listed in Step 3 above.
SSwitch On Standby Hours
SEngine Protect Hours
SSwitch On Protect Hours
SSwitch On Sleep Hours
SEngine Sleep Hours
SHigh Speed Hours
SStart cycles
To Next Page
Loading...