EasyManua.ls Logo

Carrier VVT Zone - Page 77

Carrier VVT Zone
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
VVT Zone Controller 73
Pushbutton Override • 52, 63
Reheat Min • 60
Reheat Min Damper Position • 33, 41, 60
Relative Humidity • 52
Relative Humidity Calibration • 52
Remaining Heat Delay • 63
Reset Filter Alarm • 45, 63
Reset Setpoint • 67
RH Control • 60
RH Sensor • 60, 67
RH Sensor Max Input Volts • 60
RH Sensor Min Input Volts • 60
RH Sensor Value @ Max Volts • 60
RH Sensor Value @ Min Volts • 60
Schedules • 63
Sensor Array • 67
Sensor Calculation Method • 67
Sensor Failure • 63
Sensor Invalid • 67
Sensor Type • 67
Setpoint Adjust • 52
Setpoint Adjustment • 63, 67
Setpoint Adjustment Range • 52
Shutdown • 51
Space High CO2 Alarm • 58
Space High Humidity Alarm • 58
Space Humidity Alarm • 58
Space Relative Humidity • 51, 53
Space Relative Humidity Alarm • 45, 65
Space Temp Calibration • 52
Space Temp Sensor • 65
Space Temp Sensor Alarm • 45, 65
Space Temp Source • 63
Space Temperature • 65
Space Temperature - Prime Variable • 51
Space Temperature Alarm • 45, 58, 65
SPT Sensor • 63
Standby Offset • 53
Supply Air Temp Alarm • 45, 65
Supply Air Temp Calibration • 52
Supply Air Temperature • 51, 52, 65
Supply Air Temperature Alarm • 58
System Cool Demand • 60
System Cool Demand Level • 60
System Heat Demand • 60
System Heat Demand Level • 60
System Mode Reselect Timer (minutes) • 65
System Occupancy • 60
System Outdoor Air Temperature • 60
System Outside Air Temperature • 60
System Space IAQ • 60
System Space RH • 60
System Space Temperature • 60
T55 Override Duration • 52
T55/56 • 63
Target damper position • 60
Temp Compensated Start • 63
Tempurature Compensated • 53
Term Type • 33, 51, 60
Terminal Mode • 51
Terminal Type • 51, 60
Test and Balance • 60
Timed Local Override • 67
Two-position hot water/steam heating heat • 42
Unocc High RH Alarm Limit • 45, 58
Unoccupied Cooling • 53
Unoccupied Cooling 1 • 53
Unoccupied Cooling 2 • 53
Unoccupied Heating • 53
Unoccupied Heating 1 • 53
Unoccupied Heating 2 • 53
Unoccupied High SPT Alarm Limit • 58
Unoccupied Low SPT Alarm Limit • 58
Unoccupied Setpoints • 53
Valve Type • 33, 60
Vent • 60
Vent Position • 33, 41, 60
Zone Temp • 67
Zone Temp Sensor • 67
Power specifications • 3
Power wiring • 8
Protection • 3
R
Reheat Min • 60
Relative humidity sensor • 3, 19, 43, 45
Remote occupancy sensor • 3, 20
Rnet • 12
Rnet port • 3
Rnet wiring specifications • 12
S
Schedules • 44
Sequence of operation • 40
Serial number • 49
Series fan terminals • 41
Service Configuration • 29, 33, 60
Setpoint Configuration • 29, 30, 53
Single duct with reheat • 41
space temperature sensors • 45
SPT sensors • 3, 12, 40
Start-up • 29
Status • 51
Supply Air Temperature Alarm • 58
Supply Air Temperature sensor • 3, 40
System checkout • 35
T
T55 / T56 • 14, 40
temperature sensors • 40
Duct Air Temperature sensor • 1, 3, 16, 40
SPT sensors • 3, 12, 40
Supply Air Temperature sensor • 3, 40
Terminal modes • 69
Test and Balance • 36, 60
Troubleshooting • 48
U
Unit Configuration • 29, 30, 52
V
Vent • 60
Virtual BACview • 29
VVT Master • 1, 46

Table of Contents

Related product manuals