CAS CI-170A - Technical Specifications; Analog and A;D Conversion Specs; Digital Part Specifications; Display Part Indicators

7
TECHNICAL SPECIFICATION
Analog Part & A/D Conversion
Load cell excitation
voltage
DC 5 V
Zero adjust range
0.05 mV∼5 mV
Input sensitivity
0.2 uV/D (Non-certification)
0.36 uV/D (Certification)
Nonlinearity
0.01 % F.S.
A/D internal resolution
1/1,000,000
A/D external resolution
1/30,000(Max.)
A/D conversion speed
320 times/sec
Digital Part
Span calibration
Full Digital Calibration
(Single pass automatic span calibration)
Input noise
below ±0.3μVpp
Input impedance
over 10MΩ
Display
7 Segment(6 digit)
Maximum capacity
999999
Division
×2, ×5, ×10, ×20, ×50
Display below zero
“-“ minus signal
Permitted limit tare
Full capacity
Display Part
Description
“STABLE” ■LAMP
Weight is stable
“TARE” ■LAMP
Tare is used
“NET” ■LAMP
ON(NET weight), OFF(GROSS weight)
“HOLD” ■LAMP
Hold in Weight
“ZERO” ■LAMP
“0” kg
“kg” ■LAMP
Use unit kg
“t” ■LAMP
Use unit ton