129
b. Scale ID
① Scale ID setting mode.
User may set the scale ID 1~6 by pressing
numeric keys. If you want to change the scale
ID, exit main menu and enter this menu again.
For example, set 1.
“1” is master scale
“2” ~ “6” is slave scale.
c. Connect Check
Choose the FLoAt by pressing
key. (Use key to move)
The user can check the connection as shown on the right.
d. Zigbee Pan ID setting
Press appropriate numeric keys (1~65535) to input Zigbee channel.
e. CLONE
All data (PLU,Setting value, etc)
To Next Page
Loading...
