12
Chapter 22. FLOAT(Menu code 1B00)
This chapter explains how to set RS-485 mode (RS-485 option)
Table 10 : FLOAT
FLOAT Minimum Maximum Remark
Scale ID 1 6
Type 0~2
0: Don’t use
1:Wired
2:Wireless
BAUD Rate (bps; bit per sec.) 9600, 19200, 38400, 57600, 115200
User should turn off
and on the scale
after setting new
“Baud Rate”.
Master Ye s o r N o
Master Scale = Yes
Salve Scale = No
Slave 1 ~ 6 Ye s o r No
Connect Scale = Yes
Disconnect Scale = No
a. Use FLAOTING CLERK
①Press
key to enter main menu, and
enter PASSWORD. And then press go
to Floating clerk setting mode from main
menu.
② Press
to get into Floating Clerk setting
mode.
0: Do not use, 1: use RS485, 2: use zigbee③
To Next Page
Loading...
