7. Weight Comparison Function(HI/OK/LOW)
7-1. How to compare weight
① Press the MODE key until
the display shows “WL OFF”.
It means that weight limit
function is deactivated.
②Press the HOLD key to
activate this function, the
display shows “WL ON”.
③Press the SET key to set up
low value, the display shows
“L000.00”.
④ Press the HOLD(▲) or
PRINT(▼) key to have
number up or down. To enter
next digit, press the SAMPLE
key.
⑤Press the SET key to set up
high value, the display
shows “H000.00”.
⑥Press the HOLD(▲) or
PRINT(▼) key to have
number up or down. To enter
next digit, press the
SAMPLE( ) key.▶
⑧ If you set up LOW/HIGH limit wrong, “WL ERR” will be shown on the display. Then you have to set it
up again. For example) LOW=100.00kg HIGH=90.00kg High limit is lower than Low limit.
⑨ Press the MODE key to go to weighing mode.
⑦ Press the SET key, the
display shows “WL ON”.
To Next Page
Loading...
Need help?
General
