25
ERROR MESSAGES
Error
Message
on
Display
Description Solution
"Err 0"
The "Err 0" occurs when scale is
not stable.
Remove unstable facts.
"Err 1"
The "Err 1" occurs when a current
zero point has shifted from the last
span calibration.
Please call your CAS dealer.
"Err 3" The "Err 3" is an overload error. Please remove the weight.
"Err 9"
The "Err 9" is no weight error.
When scale is in counting mode,
you must load the weight.
If you have no weight on your
scale, you can see this error
message.
Please load the weight on your tray.
“Err 14”
The "Err 14" means calibration
range is not correct.
Please call your CAS dealer.
SERIAL INTERFACE
To Next Page
Loading...
