9
④ To release the TARE function, remove an item and
container from the platter and press the TARE key.
3. Counting Mode
■ If you want to count parts, first you have to set sample size.
OR
① Press the MODE key until the display shows “PCSSET”. Make
sure that PCS lamp is on. If you have set sample size before,
the display shows “0”.
②Press the SAMPLE key,
then the display shows “10”.
③If you want to increase sample size, press the SAMPLE key.
The display shows 10, 20, 30, 40, 50, 100, 150 and 200 every
time pressing the SAMPLE key.
④If you set sample size to 10, place 10 samples on the platter.
To Next Page
Loading...
Need help?
General
