16
⑧ If you set up LOW/HIGH limit wrong, “CL Err” will be shown on the display. Then you have to set it
up again. For example) LOW=00100, HIGH=00090 or LOW=00100, HIGH=00100
⑨ Press the MODE key to go to weighing mode.
⑩ Suppose that the High limit of 200 and the Low limit of 80 are set up. In this condition, OK lamp is
lighted on if the weight is 120, HI lamp is lighted on if the weight is 220 and if the weight is 60,
LO lamp is lighted on. It beeps as fixed on User Setup Mode.
(Refer to Setup Mode Table on page 17)
⑦Press the SET key, the
To Next Page
Loading...
Need help?
General
