Need help?Do you have a question about the CAS NT-501A and is the answer not in the manual?
General| Brand | CAS |
|---|---|
| Model | NT-501A |
| Category | Accessories |
| Language | English |
Essential safety guidelines for operating the weighing indicator.
Details essential operational capabilities such as data saving and filtering.
Technical details of the analog part and analog-to-digital conversion.
Explains the usage of Zero, Tare, and G/N keys for weighing operations.
Step-by-step instructions for connecting the load cell.
How to connect via RS-232C and configure data transmission format.
Lists available commands for controlling the indicator via serial communication.
Procedures for accessing and using the indicator's test functions.
Overview of the different diagnostic tests available.
Steps to access and move through calibration menus.
Lists the available calibration functions (CAL1-CAL7).
Setting the scale's maximum capacity and minimum division.
Procedures for performing span and zero calibration.
Steps to access and use the set mode for configuration.
Lists all configurable parameters (F01-F65).
Configuring data transmission modes and device identification.
Configures the relay output mode (Limit, Checker, Packer).
Steps for performing zero compensation on the scale.
Procedure for entering the high limit value for the scale.
Steps for properly sealing the rear panel and load cell connector.
Lists common weighing mode errors and their causes.
Lists common calibration mode errors and their causes.
To Next Page
