Case CX80 - Level in the Reservoir; Accessing the Hydraulic Reservoir - CX75 SR, CX80; Filling the Hydraulic Reservoir - CX75 SR, CX80

CHAPTER 5 - LUBRICATION, FILTERS, AND FLUIDS
5-34
Issued 8-04 Bur 6-34551NA
LEVEL IN THE RESERVOIR
1. Park the machine on flat, horizontal ground.
Retract completely the bucket and arm cylinder
rod. Raise the dozer blade (if equipped). Lower
the attachment to the ground. Shut down the
engine and remove the starter switch key.
CT02D051
Figure 84
2. Using the starter switch key, open the right-hand
side door.
3. The oil must be located in the middle of the
indicator. Top up if necessary. See Filling.
CT02D058
Figure 85
ACCESSING THE HYDRAULIC RESERVOIR -
CX75SR, CX80
1. Open the 2 hoods (1) and (2) and lock them with
the lever (3).
CT02D070
Figure 86
2. Remove the toolbox (1):
A. Loosen the 2 screws (2) by a few turns.
B. Move the toolbox (1) in one direction and lift it
to remove it from its housing.
CT02D071
Figure 87
3. Lift the windshield washer reservoir upwards to
remove it from its housing.
CT02D072
Figure 88
FILLING THE HYDRAULIC RESERVOIR - CX75SR,
CX80
1. To access the hydraulic reservoir, see Accessing
the hydraulic reservoir.
2. Clean the plate and also around the plate.
1
2
3
2
2
1