CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
6-7
6-34551NA Issued 8-04 Bur
INSTALLATION
1. Place the track on the sprocket wheel and on the
side-member.
CS98B246
Figure 15
2. Place the tubes in the notches of the track in
front of the idler wheel.
CS98B247
Figure 16
3. Operate the travel lever of the track concerned in
the reverse travel direction. Stop the movement
when the tubes are pressing against the idler
wheel.
4. Stop the engine and remove the starter switch
key.
CS98B248
Figure 17
5. Place the track on the idler wheel.
CS98B209
Figure 18
6. Operate the travel lever of the concerned track to
remove the tubes from the track.
7. Adjust the tension. See Track tension value.
CS98B249
Figure 19
To Next Page
Loading...
