CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
6-14
Issued 8-04 Bur 6-34551NA
REPLACING A BUCKET - CX135SR
REMOVAL
1. Place the bucket flat on flat, horizontal ground.
Operate the attachment controls so that the
arm/bucket linkage pin is not gripped by the
weight of the arm.
2. Stop the engine and remove the starter switch
key.
3. Remove the retaining rings and pins.
CT02D210
Figure 37
4. Remove the bucket pins.
CT02D211
Figure 38
5. Start the engine, disengage the attachment from
the bucket and save the linkage seals for re-use.
CT02D212
Figure 39
INSTALLATION
1. Make sure the bucket is in a stable position.
2. Install the linkage seals on the arm bushing
shoulders. Change them if necessary.
3. Start the engine. Extend the bucket cylinder rod
to bring it into its housing. Stop the engine and
remove the starter switch key.
CT02D212
Figure 40
4. Install the arm/bucket linkage pin and then install
the retaining pin and ring.
5. Start the engine. Stop the engine and remove the
starter switch key.
CT02D213
Figure 41
6. Install the connecting rod/bucket linkage pin and
then install the retaining pin and ring.
7. Push the seals back into their housings.
8. Grease the linkage pins.
CT02D210
Figure 42
To Next Page
Loading...
