Case CX80 - Radiator and Oil Cooler; Maintenance Specifications; Cleaning

CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
6-9
6-34551NA Issued 8-04 Bur
RADIATOR AND OIL COOLER
MAINTENANCE SPECIFICATIONS
Check for leakage...........................................................................................................Every 10 hours or every day
Clean .................................................................................................................................................Every 250 hours
CLEANING
Shut down the engine, remove the starter switch key,
open the rear left-hand side door and the engine
hood.
Make sure your face is protected before using
compressed air.
Clean the radiator and the oil cooler:
Dry dust: use compressed air.
Mud: use a water jet.
Greasy dust: use perchlorethylene.
The use of trichlorethylene is strictly forbidden.
CX75SR, CX80
1. Loosen the six wing nuts (1) and remove the
three protective grilles (2) to access the radiator.
2. Install the grilles (2) and the wing nuts (1) then
close the engine hood and the rear left-hand side
door.
CT02D187
Figure 22
CT02D037
Figure 23
CX135SR
1. Loosen the four wing nuts (1) and remove the
two protective grilles (2) to access the radiator.
2. Install the grilles (2) and the wing nuts (1) then
close the engine hood and the rear left-hand side
door.
CT02D195
Figure 24
CT02D036
Figure 25
WARNING: Before any travel operation
make sure that the locking of the engine hood
is correct.
1
2
1
2