CHAPTER 4 - OPERATING INSTRUCTIONS
4-17
6-34551NA Issued 8-04 Bur
3. Place the control lever (s) in the position
corresponding to the downward movement
required.
CT02C199
Figure 49
AUXILIARY HYDRAULIC CIRCUITS
Your machine has two types of auxiliary hydraulic
circuits. One circuit is for single flow equipment, such
as hydraulic breakers. The second type of circuit is
designed for two flow use such as crushers.
Contact your authorized dealer in order to adjust the
pressure and the flow required for the use of the
option correctly.
CONFIGURING THE HYDRAULIC BREAKER,
DEMOLITION GRAB TO A FLOW OR BUCKET
1. Connect the accessory to the supply valves at
the end of the arm.
2. Using a hex wrench, turn the supply valves 90
degrees to the left (I) to open them.
CT02C287
Figure 50
3. Remove the 2 screws (1) then the plate (2).
CT02C185
Figure 51
CX75SR, CX80
4. Remove the 4 screws (1) then the plate (2).
CT02C217
Figure 52
CX135SR
5. Remove the screw (1) then bring the flow
selector valve to position (B), reinstall the screw
(1) in position (B).
CT02C186
Figure 53
6. Make sure that the switch (1) located on the
left-hand arm is in the desired position.
1
2
1
2
1
1
B
To Next Page
Loading...
