Case CX80 - Greasing the Turntable Teeth

CHAPTER 5 - LUBRICATION, FILTERS, AND FLUIDS
5-16
Issued 8-04 Bur 6-34551NA
CT02C285
Figure 19
EVERY 50 HOURS - CX75SR, CX80
Blade . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (2)
Blade cylinder. . . . . . . . . . . . . . . . . . . . . . . . . . . . (4)
CT02C286
Figure 20
EVERY 50 HOURS - CX135SR
Blade (if equipped) . . . . . . . . . . . . . . . . . . . . . . . . (2)
Blade cylinder (if equipped) . . . . . . . . . . . . . . . . . (4)
CT02C263
Figure 21
GREASING THE TURNTABLE TEETH
Every 500 hours, remove the first access plate (1)
and the 2 screws (2), remove the second plate (3)
and the 2 screws (4), check for damage on the gear
teeth and also the general condition of the gear
teeth.
If the gear surface is not well greased, add grease.
If the grease is white due to moisture content, etc.
replace it with new grease.
If water accumulation is found:
1. Remove the protective panel from the lower
central area.
2. Remove the plug.
3. Discharge the water or contaminated grease.
4. Install the plug.
5. Insert new grease through the port, then install
the panel (3) and (1).
CX75SR, CX80
CT02D004
Figure 22
CT02C264
Figure 23
1
2
2
3
4
4