Case CX80 - Page 143

CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
6-11
6-34551NA Issued 8-04 Bur
CT02D204
Figure 29
CX75SR, CX80
1. Remove the mounting bolts (1). Use the
adjustment screws (2) to push the alternator
inwards.
2. Remove the belts that are worn out.
3. Install one or two new belts.
4. Adjust the belts using the screw (2).
5. Tighten the mounting bolts (1).
6. Run the engine for about an hour and then check
the belt tension again.
CT02D201
Figure 30
CX135SR
IMPORTANT: The two belts have to be changed at
the same time.
1. Remove the mounting bolts (1). Use the
adjustment screws (2) to push the alternator
inwards.
2. Remove the belts that are worn out.
3. Install one or two new belts.
4. Adjust the belts using the screw (2).
5. Tighten the mounting bolts (1).
6. Run the engine for about an hour and then check
the belt tension again.
CS99A852
Figure 31
2
1
2
1
1