Case CX80 - Page 49

CHAPTER 3 - INSTRUMENTS AND CONTROLS
3-21
6-34551NA Issued 8-04 Bur
1. Suspension adjustment
The adjustment can be done from 50 to 120 kg
(110 to 264 lb.). Turn the switch (1) in the + or -
direction.
CT02C076
Figure 48
2. Forward/reverse position adjustment
Hold the control (2) in raised position, slide the
seat to the required position and then release the
control.
CT02C077
Figure 49
3. Seat plate adjustment
To raise or lower the front of the seat, hold the
lever (3) in raised position. Move with the seat to
the desired position and then release the lever.
To raise or lower the rear of the seat, hold the
lever (3) in lowered position. Move with the seat
to the desired position and then release the lever.
CT02C078
Figure 50
4. Seat back angle adjustment
To adjust the seat back angle, hold the lever (4)
in raised position. Move with the seat back to the
desired position and then release the lever.
CT02C079
Figure 51
5. Lumbar support adjustment
Use the inflation bulb (5) to inflate the lumbar
support. Press the button on the tip of the
inflation bulb (5) to deflate the lumbar support.
CT02C080
Figure 52
1
2
WARNING: Before tilting the seat back it is
essential for the armrests to be in raised
position to prevent them from fouling the
control levers.
3
4
5