Casella CEL-35X dBadge Users Handbook – Page 10
4 CHARGING THE CEL-35X
4.1 Charging
The CEL-35X dBadge uses internal NiMH batteries. Ensure the
CEL-35X is fully charged prior to use by placing in the charger as
shown in Figure 5. Note the CEL-35X will fit into charger units
regardless of which mounting clips are attached.
Figure 5
Ensure the power supply (-PC18) is connected and the supply is
switched on. The CEL-35X dBadge will automatically switch on
during charging and display how much charge is within the
dBadge, as shown in Figure 6. When the CEL-35X dBadge is
charging the red LED will flash and the charge symbol will
rotate on the top right of the display. The dBadge will display ‘Full’
once charging is complete and the LED on the front of the
instrument will turn blue. This should take approximately 1.5 hours
from a discharged state. A charging time of about 30 minutes will
be sufficient to perform greater than 8 hours of measurement.
Once fully charged, the CEL-35X holds enough charge to run for
approximately 32 hours.
To Next Page
Loading...
Need help?
General
