Controlling the Sound of a Performance
EN-23
You can use tone memory to register tone and layer settings, octave shift settings, and other settings to
main tone buttons. You will then be able to recall the registered settings when you need them to
perform a particular song, etc.
1.
While holding down TONE VARIATION, press the main button to which you want
to register the tone settings.
This will sound a notification tone and cause the TONE MEMORY TONE VARIATION LED to
flash momentarily, and register your tone settings.
• The TONE MEMORY TONE VARIATION LED and the main tone button where the setting was
stored will light to indicate that the tone is selected.
• You can register up to seven setups, one to each of the main tone buttons.
■ Registered Settings
• Sustain
• Tone (main, layer)
• Layered
• Part octave shift (main, layer)
• Sustain time (main part, layer part)
• Part volume (main, layer)
• Pedal effect part (main, layer)
• Reverb type
Registering a Tone to a Main Tone Button (Tone Memory)
To Next Page
Loading...
Need help?
General
