— 10 —
Connecting the Cradle to a Computer
The cradle has a USB cable for connection to a computer. Connect the end of the cable to a USB port of the
connected computer.
• See "Required System Configuration" on page 5 for details on the type of computer system required
for use with the cradle.
• The above illustration is one example of possible connection configurations. The locations and
layouts of USB ports vary from computer to computer. See the documentation that comes with
connected computer for full details on connecting cables to it.
• Note that after connecting the cradle to connected computer, it is neccessary to make certain
ActiveSync settings on connected computer to enable data transfers. See the
ActiveSync Help
for
details about setting up and using ActiveSync.
To place the CASSIOPEIA onto the cradle
Make sure that unit power is turned off before it is placed it onto or remove it from the cradle.
Use the following procedure to place the unit onto the cradle.
1. Place the cradle on a desk or other flat, level surface.
2. Turn off the unit.
3. Orient the unit in relation to the cradle as shown in the illustration below.
Make sure the raised part of the cradle enters into the recess on the back of the unit.
2
1
To Next Page
Loading...
